Purchasing Information (links to our Yahoo store)
Output assembly re-installation.
Turn the printer around so you are facing the front
of the printer. Notice the two white hook-shaped tabs circled
below on the output assembly. The hook-shaped tabs slide into
the slots in the frame. The slot on the right side isn't visible
so you need to go by feel. The easiest way to do this is to tip
the assembly forward and insert the tabs in the slots. Then rock
the top of the assembly back so the tabs on the back side of the
assembly lock into place as shown in the lower image. This takes
a little patience and you might need to gently rock the assembly
back and forth several times to get it seated and locked into
place. Make sure to press the metal grounding tab back into place
as shown on the previous page.
Finally, re-install the top panel, side panel,
and toner. That's it! You're done!
