Open the toner cartridge door and use a pair of needle-nose pliers to pinch the head of the lever that supports the toner door. Pinch the head of the lever and push it through its hole, as shown below.
Remove the four screws holding the top cover in place, as shown in the two figures below (remove two from the front of the top cover, and two from the rear of the top cover).
Use a flatblade screwdriver to release the latch on the left side of the toner door. Then lift the top cover straight up and away from the printer.
Now the left cover must be removed. Release the latch shown below, and simultaneously lift the cover up and outward to remove it.
Next, unhook the two springs supporting Tray 1 from the black printer frame. Then, at the locations pointed to by red arrows below right, pry the pivot arms loose from Tray 1.
Slide the bottom of Tray 1 to the left to remove it. Then rotate the pivot arms (levers shown below right) upwards and remove the top of Tray 1.
| |
|
| Press and hold the release tab on the outer edge of the left idler roller and begin sliding the idler roller away to the left. If the idler rollers catches on the separation pad beneath it, hold the separation pad down with one hand and slide the idler roller with the other hand. |
Press and hold the release tab on the outer edge of the right idler roller and slide this one to the right. Again, hold down the separation pad if necessary. |
 |
 |
| |
|
| Strongly pinch the release tab on the right side of the pickup roller. You will have to use some force as you pinch the release tab upwards, and then slide the roller to the right. |
 |
| |
| Rotate the pickup roller on its shaft, rotating it towards you to free the roller |
Lift the pickup roller off its metal shaft |
|
|
Before you install the new pickup roller, the separation pad must be removed and replaced.
Continued . . .
|
