Turn the power off and unplug the printer. Wait 15 minutes for
the printer to cool.
At the back of the printer press the two release buttons on the DIMM cover (circled in red below). Then swing the back cover out slightly away from the printer.
Next open the toner cartridge door and press the release button located on the right hand side. Grasp the front and rear of the DIMM cover and swing it out slightly at the back, away from the printer. Then slide the DIMM cover towards the front of the printer to release it from the printer frame.
Next open the rear output bin (the back gate) and lift it to an angle that allows you to disengage the two pins on each side of the bin. With the pins disengaged, lower the rear output bin down to rest on the work surface.
Remove the two screws circled in red below from the rear cover.
Looking inside the Tray 2 cavity, use a flatblade screwdriver to release the two tabs--one on each side of the rear cover.
Next remove the rear cover from the printer.
Remove these two screws circled in red below to free the plastic fuser cover.
Now remove the fuser cover from the printer.
Use a small flatblade screwdriver to disengage the tab on the connector shown below and unplug the connector.
Next unplug the two connectors shown below.
Now remove the two screws holding the fuser in place (circled in red below).
With the screws removed, you can now pull the fuser straight out and away from the printer.
Install the new fuser and replace the two fuser screws. Replug the three connectors. Replace the fuser cover and secure its two screws. Replace the back cover and the DIMM cover.
|
