Turn the power off and unplug the printer. Wait 20 minutes for
the printer to cool.
Open the back door of the printer, using enough force that the door opens completely and the hinge locks disengage, as shown below.
Remove the 2 screws circled in red below.
| Close the back door, and then flip the printer so that it rests on its face. |
 |
 |
Next swing open the paper guard which shields the back of Tray 2 when it is installed.
Looking inside the Tray 2 cavity, use a flatblade screwdriver to release the two tabs--one on each side of the rear cover.
Next remove the rear cover from the printer by pulling down and away.
Fuser Installation Continued . . .
|
