Turn the printer off and unplug the power cord. The fuser might
be hot if you have been using the printer. As a safety precaution
wait 30 minutes for the fuser to cool before proceeding.
If a duplexer is installed, remove it from the back of the printer as shown below.
Next, lower the rear output bin cover as shown below.
Flex the arms on the plastic output bin slightly to remove one side of the tray at a time. Set the output bin cover aside.
While grasping onto both sides of the fuser, push the blue levers upward and pull the
fuser straight out.
Install the replacement fuser by inserting it and
aligning the left side first. Push the fuser firmly--listen for the sound of both blue levers clicking into place. If the fuser does not click into place you run the risk of wearing out both the fuser and the gears that drive the fuser prematurely. Re-install the plastic rear output bin.
That's it for the fuser! Remember to send your fuser
back to us if you purchased your maintenance kit on exchange. Ship
it back in the box we sent if you still have it.
|
Purchasing
Information - although the installation instructions are the same for the following maintenance kits, each kit has a unique fuser. Please make sure to order the kit that corresponds to your printer.
