| With the rubber replaced, the bar needs to be re-secured. Begin by angling both of the white collars (the collars where the screws were removed) with their tabs pointing downwards. Line these tabs up with their corresponding holes and settle the bar down in its groove. |
 |
With the bar somewhat in place, use a flashlight to inspect the right hand side. Locate the metal tab shown below and wiggle/rotate the bar so that the metal tab rests in the curve of the brassy-colored clutch arm.
With the white collars aligned properly, the entire bar fitted in its groove, and the metal tab resting in the brassy curve on the right hand side, you can now replace the screws to hold the roller bar in place.
Next reinsert the toner cartridge guide plate, screw holes towards the back of the printer. Then replace the two screws previously removed.
Reinstall the toner cartridge and you're done! Don't forget to mail back your old fuser if you purchased this kit on exchange.
|
Purchasing Information
