HP Laserjet 5000/5100 Tray 1 Pick-up Roller and Separation Pad Installation

Open the top cover and remove the toner cartridge. Flip up the green handle of the registration assembly pictured below.

Squeeze the black tab on the right side of the pick-up roller to release the roller, and slide the roller to the right.

The roller is sandwiched between two black discs. Slide the roller back to the left so it is centered between the discs and pull the roller straight up and out.

Before replacing the transfer roller, replace the separation pad.

Remove the front tray to make getting at the separation pad easier. Fold down the front tray and unclip it at the two points circled below.

Flip the inner tray up and the outer tray will come off by sliding it to the right. Remove the inner tray by letting it rotate all of the way down. It should fall right out of its pivot/hinge.

Use a small flathead screwdriver to pry out the separation pad. With your other hand inside the printer, remove the pad. Firmly press the new separation pad (silver edge forward) in its holder and press down until it clicks into place.

Install the new pick-up roller by making sure the thumb grip is on the left. You can only install the roller one way, so flip it around if you think you have it backwards. Slide the roller to the right until it is seated against the right black plastic disc. You might have to slightly lift and wiggle the roller to get it seated. Now slide the right disc and the roller all of the way to the left until it clicks into place.

Contents

1. What is included in a Printertechs Laserjet 5000 maintenance kit?
2. Fuser installation.
3. Transfer roller installation.
4. Tray 1 (Multi-purpose tray) pick-up roller and separation pad.
5. 250 sheet tray pick-up rollers and separation pad.
6. 500 sheet tray pick-up and separation rollers.