HP Laserjet 9000 & 9050 Maintenance Kit Installation - Rollers for the Optional Tray 1

 Purchasing Information
To check prices or purchase an HP Laserjet 9000 / 9050 maintenance kit click here, or call us toll free at 866-352-7108.

Tray 1, the multipurpose tray, is an optional feature for the LaserJet 9000. Rollers for Tray 1 maintenance are not included in our Standard maintenance kit, only in the Extended Kit. Consult the diagram below if you are not sure you have Tray 1 on your printer. If you don't have Tray 1, or if you did not purchase the Extended Maintenance Kit with the extra rollers, click here to skip this section.

Open Tray 1. Locate the plastic cover pictured below, which is hiding the three rollers you need to replace.

Remove this plastic cover by pressing its tab down, lifting the cover upwards, and then sliding the cover towards you and free.

Press the tab on each roller and slide each roller of its shaft.

Begin replacing the rollers back to front. The two grey&blue rollers go in the back; the single black & grey roller sits in the front. The rollers should lock into place on the shaft as they are reinstalled.