Insert a small flathead screwdriver in the slot under the separation
pad circled below. Twist the screwdriver to loosen the pad. It might
take a little effort but the pad will lift up and out.
Insert the new pad making sure the shiny metal edge is pointing forward. The separation pad can be difficult to press into place. The trick is to not press down in the middle, that will make it very hard to lock down. Press down on either the left or right side to get one side of the pad locked in, then press on the other side.
Slide a new pickup roller on the shaft until it clicks into place. Reinstall the plastic envelope feeder access cover.
|
