Turn the printer off and unplug the power cord. The fuser might
be hot if you have been using the printer. As a safety precaution
wait 30 minutes for the fuser to cool before proceeding.
If a duplexer is installed, remove it from the back of the printer.
Next, lower the rear output bin cover as shown below.
Flex the plastic output bin slightly to remove one side of the tray
at a time. Set the output bin cover aside.
Flip the two blue tabs up (circled below), pull the
fuser straight out.
Install the replacement fuser by inserting it and
aligning the left side first. Flip the two blue tabs back down and
re-install the rear output bin.
That's it for the fuser! Remember to send your fuser
back to us if you purchased your maintenance kit on exchange. Ship
it back in the box we sent if you still have it.
|
To
check prices or purchase an HP Laserjet 4100 maintenance kit 
