608-831-2396 or 866-352-7108

HP LaserJet 5si Tray 1 pickup roller and separation pad installation instructions

purchase here

Installing the Tray 1 pickup roller and separation pad.


Important note: These parts are only included in PrinterTechs' extended kit, not in the standard kit. If you purchased the standard kit, you can skip this installation step and proceed to the next page in the instructions.

Open Tray 1 (the manual feed tray) and remove the black plastic cover if it is installed. Grab at the arrow pictured below with your thumb and index finger, slide to the left and pull out.

Remove the pick-up roller by pinching the tabs on the end of the roller and pulling the roller to the left off of the shaft.

Insert a small flat-head screwdriver into the slot below the separation pad and pry off the separation pad (pictured below).

Install the new separation pad making sure the metallic edge is facing forward. Install the pickup roller by sliding it all the way to the right. Replace the black plastic cover and close the tray 1 door.