Email

HP LaserJet 4100 Tray 1 pickup roller installation instructions

purchase here

Installing the Tray 1 pickup roller.

Remove the toner cartridge if it hasn't already been removed. Open Tray 1 (flips down). Remove the plastic piece circled below by pulling straight out.

Next take a small flat head screwdriver or your fingernail and pop open the blue tab on the pick-up roller. Then pull the roller straight up and out.

Before you install the new pickup roller, you should proceed to the next step and install the separation pad. (The separation pad sits underneath the pickup roller and needs to be installed first.)

Other Steps in HP LaserJet 4100

HP LaserJet 4100 fuser installation instructions
HP LaserJet 4100 transfer roller installation instructions
HP LaserJet 4100 Tray 1 pickup roller installation instructions
HP LaserJet 4100 Tray 1 separation pad installation instructions
HP LaserJet 4100 feed and separation roller installation instructions
HP LaserJet 4100 D-shaped pickup rollers installation instructions
HP LaserJet 4100 reset maintenance count instructions