608-831-2396 or 866-352-7108

HP LaserJet 4350 Tray 1 pickup roller installation instructions

purchase here

Installing the tray 1 pickup roller.

Open Tray 1 (flips down). Remove the cover from the envelope feeder slot (the plastic piece shown below) by pulling it straight out--see diagram below right if you have an envelope feeder installed.

Use your fingers or a flathead screwdriver to pry outward on both of the tabs shown below to free the pickup roller.

Remove the pickup roller. (Wait to replace the pick-up roller until after you have replaced the separation pad in the next step.)